Waterproofing, explained
How a shower is waterproofed before it's tiled
Tiles and grout don't stop water. The membrane underneath does. Scroll through a shower floor being built, layer by layer, and see why the part you never see matters most.
Drawing, not to scale.
Back to a sound base
On a renovation, the old tiles, screed and membrane come out, down to the slab and the wall sheeting. Anything soft, cracked or damp gets fixed now, while it's easy to reach.
Set the falls
A sand-and-cement screed is laid so the floor slopes gently to the waste. Water should run to the drain on its own and never sit in a corner.
Seal the corners and the waste
A primer helps the membrane grip. Where the wall meets the floor, a flexible bond breaker lets the house move without tearing the membrane, and a puddle flange around the waste carries any water that gets under the tiles into the pipe.
Membrane on, then wait
The liquid membrane goes on in coats, across the floor and up the walls. In the shower, the Australian Standard for wet areas (AS 3740) takes it to at least 1800 mm above the floor. Then it's left to cure for as long as the maker says. This is the step that can't be rushed.
Tiles go on
Only on a cured membrane. Tiles are bedded in adhesive, with the floor tiles following the falls, so water still finds its way to the drain.
Grout and silicone
Grout fills the joints between tiles. The corners and the line where wall meets floor get flexible silicone instead, because that's where the room moves, and grout there would crack.
Grout isn't waterproof
Standard grout and many tiles let water through over time. That's normal, and it's why the membrane underneath is the real waterproofing. When a shower leaks, the tiles are rarely the cause: the layer under them is.
Signs a shower is leaking
- Tiles that sound hollow or have lifted
- Grout that keeps cracking or going dark
- Mould or a musty smell at the skirting
- Swollen doorframes or vanity bases
- Damp patches on the other side of the wall
What to ask before you tile
- Who is doing the waterproofing?
- What's their QBCC licence number?
- Which membrane, and how long will it cure?
- Will you get a certificate when it's done?
Waterproofing questions
Good to know
Which parts of a bathroom need waterproofing?
The shower area gets the most: the whole shower floor, and the walls to at least 1800 mm. The rest of the bathroom floor and the bottom of the walls need protection too, and so do laundries and balconies. The Australian Standard for wet areas, AS 3740, sets out exactly where.
Can I use the bathroom straight after it's waterproofed?
No. The membrane has to cure before it's tiled over, for the time the manufacturer specifies, and the tiles, grout and silicone need time to set after that. Your tiler will tell you when the room is ready to use.
Is waterproofing regulated in Queensland?
Yes. Waterproofing is regulated building work in Queensland, overseen by the QBCC. It's reasonable to ask whoever does yours for their licence number and for a certificate once it's done.
Can a leaking shower be fixed without ripping it out?
Sometimes a failed seal or cracked grout is the culprit, and regrouting or resealing helps. If the membrane underneath has failed, the lasting fix is to strip the shower back and waterproof it properly. A tiler can look at the signs and tell you which it is.
Planning a bathroom?
Talk to Impression Tiling about the tiling, and what goes underneath it.